Factory Direct: Get Eco-Friendly Water-Based Mould Release Agent

Spray method: choose the spray device with good spray effect, the pressure control within 4-5 kg, the mold surface fog evenly sprayed, each place must spray in place, spray evenly with scraping roll Wipe method: wipe the mold surface with wet cotton yarn (unpeeling cotton yarn or cotton yarn towel) infiltrated with the mold liquid to form a uniform liquid film layer 1. Water ratio: After initially using 1:3 water (1KG mold agent + 3KG water) for a period of time, the water ratio is gradually increased to 1:5 (aluminum mold: 1:2-3 water ratio can be considered, and the water ratio can be increased according to the mold situation in the later stage).Please use clean tap water. 2 Adjustment: add stripping agent in the clean bucket, and then add clean warm water in proportion (heat no less than 40 degrees in winter). After adding the water is finished, stir for 5 minutes and apply the electric tool. 3. Spray mold solution: Before spraying, please polish the rust removal and clean the abrasive. The abrasive must be kept clean with no rust oily concrete dirt. 4 In winter, please run water at the ratio of 1:3-4 to improve the concentration of demolding liquid to ensure the demolding effect. 5 Apply 20 minutes (turn colorless and transparent) to pour concrete. 6 Production stairs to appropriately reduce the proportion of water, the Yin Angle must be painted in place 7 Try to use out as much day as possible after mixing the water, please stir well overnight and then use 8 Do not drizzle with water and keep it cleanindoor closed preservation, cold and freezing in winter, explosion-proof and rain in summer, do not put together with combustible products, away from the fire sourceNatural environmental protection 1). The P H value is neutral and non-toxic, so it has no stimulation to workers' skin and no corrosion to reinforced concrete and steel mold; 2). This product is a natural natural decomposition material, does not affect the subsequent plastering or batch putty, is an environmentally friendly material. 3). Surface tension is small, easy to flow span and rapid membrane formation 4). With the rust resistance function, can protect the mold, its film layer is tough. Easy to remove mold Have a good isolation performance, easy to remove the mold Reduce bubbles This product can greatly reduce the production of air bubbles and surface defects Keep integrity After mold removal, the surface can be kept smooth and smooth, edges and corners intact, maintain the concrete, without miscellaneous color

order number	Experimental project		Standard requirements	result
1	Dry into membrane time		10-50min	35min
2	Demodal performance	surface	Can smoothly off-mold, keep the surface complete, smooth	The ding is smooth, complete edges and corners and smooth surface
		Concrete adhesion	≤5g/㎡	3.5g/㎡
3	Rust effect on the rigid mold		not have	not have
4	stability		Uniform, with no obvious stratification	Uniform, with no obvious stratification
5	density			1.16g/㎝³
6	dynamic viscosity			20.1s
7	PH price			7

Environmental Friendly Water-based Mould Release Agent

Products Details

Featured Products

Contact us